Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - RDawson-Goodey

Pages: [1]
Troubleshooting / GA vs Statcomm
« on: September 10, 2012, 08:12:34 AM »
Hi Guys

Thanks for all the help on the previous problems, everything has worked out fine now. I do however have a question about how accurate statcomm data is.

I have both GA and statcomm on our site and to say that they both had different stats would be an understatement. Statcomm is showing that we are pushing well over 20,000 a month, whereas GA is showing that we barely reach 6000.

How is it that these differences are so large and could you think of any reasons as to why that is. Does Statcomm count RSS, spiders and bots as visitors.


Installation/Upgrading/Migration / Re: Spy Option
« on: September 07, 2012, 07:28:33 AM »
Hi Fernando

Thank you for the support, I am still unsure where I would go  enable or change this.



Installation/Upgrading/Migration / Re: Spy Option
« on: August 17, 2012, 07:15:59 AM »
Hi Fernando, Thanks for that! It worked however on the main overview and the spay page, i get a fatal error message

"Fatal error: Call to undefined function mb_internal_encoding() in /home/blogchil/public_html/wp-content/plugins/statpress-community-formerly-statcomm/classes/geoipcity.php on line 142"

Any help greatly appreciated


Installation/Upgrading/Migration / Spy Option
« on: August 15, 2012, 07:50:24 AM »
Hi all, Apologies if this is explained somewhere else, but clicking on the spy category on the plugin it says that maxmind database is not installed.

When I try and download it in the advanced section I get this message:

Any help would be great


Installation/Upgrading/Migration / Migration of Statpress to StatComm.
« on: August 15, 2012, 04:40:53 AM »
Hi Guys

I am wanting to migrate content from Statpress to Statcomm. i get to the migration option and put in all my migration details however even though the table content is there it is still saying migration disabled?

Any ideas


Pages: [1]